Fishino Shark is the third board of 32-bit Fishino family. It’s a board 100% compatible with the famous Arduino MEGA, but with a 32 bit MIPS controller and many add-ons which greatly enhance its capabilities. Among the highlights of Fishino Shark are the 32 bit MIPS controller, with 512 KBytes of flash and 128 KBytes of RAM, a stereo audio codec on board and the ability to be powered by a single cell LiPo battery, which gets automati
This enamelled solderable soft copper wire is used to wind coils or transformers and is supplied on plastic bobbins. Winding wire is available in a thickness varying from 0.1 to 1.5mm. The length of the wire depends on its thickness. Specifications Ø wire: 1.5mm wire length: 21m bobbin dimensions (mm): A: 65 B: 65 weight:…
Ultra compact (68 x 35 x 14 mm) switching power supply with USB output, short circuit protected and characterized by low power consumption under no load. Designed for a wide range of devices such as cell phones, media players, GPS, etc … Techical specifications Power supply: 100-240 Vac, 50/60 Hz Power: 7.5W Output voltage: 5…
Still a few days to get the Motors at 2 €! Based on the Allegro A4988 chip, this driver is able to control a single bipolar stepper motor with max. 2 A. You can select five motor control modes: step, half step, quarter step, 1/8 step and 1/16 step. You can also sets the…
Wifi Bee-ESP8266 is a Serial-to-WIFI module using XBEE design in a compact size, compatible with XBEE slot, applicable to a variety of 3.3V single-chip system. It can be used for Arduino, wireless data transfer, remote control. On-board switch can be used to easily select the Startup module or Upgrade firmware….
. The objective of this project is to build an Arduino voice shield to empower thousands of voice related applications! All this mostly thanks to an integrated ISD1790PY chip. This particular voice/TTS feature can be useful to integrate voice messages in alarm systems, to implement generic I/O controls in home automation or even in home…
The DHT22 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real…
Open-Electronics.org is the brainchild of a world leader in hobby electronics Futura Group srl. Open-Electronics.org is devoted to support development, hacking and playing with electronics: we share exciting open projects and create amazing products!
Open-Electronics.org is not just a container of ideas: it is also a web site lead by a team of engineers and geeks who will take part in the discussions and give support.
Our mission is to become a reference Open Source hacking site with ideas and feedback aimed to enrich the community.
