3M heating pad 20×20 cm 12V 200W

Description

Heated pad to be applied, using the 3M adhesive it comes with, under the glass bed of the 3Drag printer (20x20x20 cm). It already includes a 100 kohm NTC. Thanks to this heated bed, it will be possible to reach a maximum temperature of about 130°C on the glass bed (also depending on ambient temperature), allowing better adhesion of the printed object. It is powered at 12 V and draws about 17 A. Material: silicone rubber, print area dimensions (mm): 200×200.

Note: Given the high current draw, it is recommended to verify before use that the control board can handle the above current. If the control board cannot handle the 17 A load, an external power driver will be necessary.