Pack 10 Pcs ABS M3 spacers 10 mm long
Package containing 10 ABS spacers with internal diameter 3 mm, external diameter 7 mm and length 10 mm.Package containing 10 ABS spacers with internal diameter 3 mm, external diameter 7 mm and length 10 mm.
Package containing 10 ABS spacers with internal diameter 3 mm, external diameter 7 mm and length 10 mm.Similar Posts
Inputs/outputs controller working over the Internet through a SitePlayer Web Server
Using a SitePlayer SP1 module, it is possible to control four optoisolated inputs and four relay outputs through an Internet web page. The usage of this module is recommended for industrial and home automation. SitePlayer module is a web server which, as soon as it is connected to the Internet or to an…
Blue LASER module 2 W – 445 nm
Laser module with blue emission (445 nm) for industrial applications complying with EN60825-1 standards. Each module is tested in continuous output for 200 hours and is subject to 300 ON / OFF cycles. The module has a fan for heat dissipation, allowing the LASER to operate continuously. The module requires a 12 volt supply voltage…
NEXTION display NX3224T028 2,8 Inch
The NX3224T028 is a display of the NEXTION family which differs from the traditional display due to the presence of a microcontroller, a flash memory, a slot for inserting an SD card containing the firmware of your project, a 4-pin TTL serial interface and a free software (Nextion Editor) specifically designed to draw the graphic…
TORPEDO: an all-purpose switched-mode power supply
Having explained the theory, let’s see in practice the project of the SEPIC power supply. In this post we discussed – on a theoretical level (even if in a simplified way) – the SEPIC switching converters, also highlighting advantages and disadvantages, and giving you the basics for the calculation of their components. Let’s…
SD Card shield for Arduino
SD Card shield for Arduino Shield for Arduino equipped with SD Card slot and micro SD adapter. It has a communication interface (SPI, I²C, UART), 3.3V and 5V power switch, power status LED, reset button, jumper to set SPI pins (D11, D12 or D13), 4-pin connector for UART interface (RX, TX, VCC, GND) and…
Laboratory power supply 0-15 V / 0-2 A
Laboratory switching power supply with adjustable output voltage from 0 to 15 VDC and maximum current of 2 A. It has a short-circuit protection and LCD display with backlight indicating the voltage and current supplied. It keeps the set values reliably and independently of the fluctuations in the supply voltage or the…
