Similar Posts
DiY FM Micro Receiver
ByoeadminA small integrated SMD gives life to an excellent portable FM stereo radio receiver which can be easily created because it does not require the production of coils or the calibration of tuned circuits. The semiconductor industry continuously churns out new integrated circuits for all application areas and also for consumers and audio; among…
Pulse Oximeter SpO2 and Heart-Rate Sensor Module MAX30100
ByoeadminThe MAX30100 is an integrated pulse oximetry and heart rate monitor sensor solution. It combines two LEDs, a photodetector, optimized optics, and low-noise analog signal processing to detect pulse oximetry and heart-rate signals. The MAX30100 breakout operates from 1.8V and 5.5V power supplies and can be powered down through software with negligible standby current, permitting…
Switching power supply with USB output – 5V / 1A
ByoeadminUltra compact (68 x 35 x 14 mm) switching power supply with USB output, short circuit protected and characterized by low power consumption under no load. Designed for a wide range of devices such as cell phones, media players, GPS, etc … Techical specifications Power supply: 100-240 Vac, 50/60 Hz Power: 7.5W Output voltage: 5…
Demoboard PIC32MX – ATHENA32
ByoeadminATHENA32 is an evaluation board designed to allow the user to experiment with a broad range of peripheral of PIC32MX family without the need of additional boards or devices. It has been specifically designed to address the SW development process with Microchip 32-bit line of controllers using Microchip official toolchain (in particular MPLab X, XC32…
Winding wire Ø0.2mm – 178m – 97 ohm
ByoeadminThis enamelled solderable soft copper wire is used to wind coils or transformers and is supplied on plastic bobbins. Winding wire is available in a thickness varying from 0.1 to 1.5mm. The length of the wire depends on its thickness. Specifications Ø wire: 0.2mm wire length: 178m bobbin dimensions (mm): A: 65 B: 35 weight:…
GSM Remote Control – Gate Control
Part 4 – SMS CommandByoeadminCommands and settings can be sent by any cell phone via SMSs, as long as the message in question contains a password. Some of the commands can be composed without the use of a password (just so that they can be composed faster), provided that they are sent from one of the first eight numbers…
