Pressure Transducer 0-1.2 MPa
€18.03excl. VAT€22.00incl. VATThis transducer measures the pressure of non-corrosive gases or liquids
Robotics & development
784 products
Narrow by category
-
Sensors -
Arduino compatiblePRO midi 1284P Developer’s Board
€15.57excl. VAT€19.00incl. VATDeveloper’s board designed specifically for use with the PRO midi 1284 prototyping board
-
STEMProgrammable Robot with Manual Coding
€36.07excl. VAT€44.00incl. VATEducational robot kit with STEM (Science, Technology, Engineering, Mathematics) coding for beginners, meant to get the user started with machine building engineering and with manual coding
-
IoT (Internet of Things)ProtoA Modem Board for the Mercury System
€4.51excl. VAT€5.50incl. VATSmall board for the Mercury system with a prototyping area and provision for fitting a connector to take the ESP8266 Wi-Fi module (not included)
-
ArduinoProtoboard Shield for Arduino
€4.10excl. VAT€5.00incl. VATProto shield compatible with Arduino UNO R3 and Leonardo
-
ArduinoProtoshield for Arduino
€3.28excl. VAT€4.00incl. VATFree 2.54 mm pitch area to build your own circuit on top of Arduino, with two push-buttons, two LEDs and a mini breadboard included.
-
Arduino compatiblePrototyping board for M5STACK
€2.05excl. VAT€2.50incl. VATPrototyping board with 260 pads on a 2.54 mm pitch and a 2×15-pin male connector (M-BUS) for use with the M5STACK
-
micro:bitPrototyping Board for micro:bit
€12.30excl. VAT€15.00incl. VATThis prototyping board is ideal for getting started right away experimenting with micro:bit.
-
Raspberry PiPrototyping Board for Raspberry Pi
€4.02excl. VAT€4.90incl. VATPrototyping board made specifically to be fitted on the Raspberry Pi board through the 40-pin GPIO connector
-
Raspberry PiPrototyping Board for Raspberry Pi – Kit
€5.74excl. VAT€7.00incl. VATPrototyping board made specifically to fit the Raspberry Pi board (model B rev.2), letting you test your own applications without having to make a dedicated printed circuit board
-
Development systemsPrototyping Board with RP2040 and 868 MHz LoRa Module
€22.95excl. VAT€28.00incl. VATPrototyping board with RP2040 and 868 MHz LoRa.
-
ESP8266 / ESP32Prototyping Module for M5STACK
€3.69excl. VAT€4.50incl. VATPrototyping module complete with frame, 250 pads on a 2.54 mm pitch, 2×15 pin male connector (M-BUS), 2×15 pin female connector (M-BUS) and magnets, for use with the M5STACK
-
ArduinoPrototyping PCB for Arduino
€2.05excl. VAT€2.50incl. VATPerforated prototyping printed circuit board.
-
SensorsPT100 Temperature Sensor
€3.69excl. VAT€4.50incl. VATHighly stable and accurate, the PT100 temperature probe (i.e. a platinum resistance thermometer) can measure temperature over a range from -50°C to +450°C with an accuracy of about 0.5°C (from -10°C to +85°C)
-
AccessoriesPush-button Board with Analogue Output
€3.69excl. VAT€4.50incl. VATSimple board with 5 push-buttons and analogue output
-
Control electronicsPWM generator for stepper motor drivers
€15.98excl. VAT€19.50incl. VATPulse generator built to interface with the common types of stepper motor controller
-
IoT (Internet of Things)Quad Expansion board for the Mercury System
€9.84excl. VAT€12.00incl. VATExpansion board for the Mercury system
-
micro:bitQuick start kit with Micro:bit V2
€45.90excl. VAT€56.00incl. VATKit containing one Micro:bit V2 board, a battery holder with on/off switch for 2 AA 1.5 volt batteries, four AA 1.5 volt batteries, a micro B USB cable, a 9 gram mini RC servo, an RC servo extension lead with male dupont pins, two 5 mm yellow LEDs, two 5 mm green LEDs, two 5 mm red LEDs, six 100 ohm ¼ watt resistors, three quick-wiring terminal blocks, a set of ten crocodile clip leads, a quick start guide in English (updated for micro:bit V2) and a cardboard box designed to be used in some of your own projects.
-
SensorsRain Sensor with Control Electronics
€4.75excl. VAT€5.80incl. VATMade up of a board with a large sensing area (34×47 mm) on both faces plus control electronics, this product is particularly suited to detecting rain
-
Raspberry PiRaspberry Pi – PICO
€6.48excl. VAT€7.90incl. VATRaspberry Pi Pico is a small, fast and versatile board built using the RP2040 chip, a brand-new chip designed by the Raspberry Pi Foundation in the United Kingdom