16×2 LCD display with pre-soldered pin header
€4.92excl. VAT€6.00incl. VATLCD display with pre-soldered pin header
New products
All new products →
Multicolour Layered Case for Raspberry Pi 2 and 3 Model B / B+
€5.53excl. VAT€6.75incl. VAT
Read more
ESP32 – Development board with Wi-Fi, Bluetooth and USB Type-C connector
€11.48excl. VAT€14.00incl. VAT
Read more
2-Channel Programmable Signal Generator – 1 nHz to 80 MHz, 300 MSa/s Sample Rate
€278.69excl. VAT€340.00incl. VAT
Read more
All products
Narrow by category
All
Robotics › Sensors187
Enclosures143
Arduino compatible115
Raspberry Pi115
Breakout boards › Sensors112
Buttons, switches & joysticks109
Actuators100
Soldering100
Arduino94
Resistors86
Displays84
Lab cables83
LEDs83
Light bulbs78
Counts based on the first 4198 matches.
-
Displays -
ESP8266 / ESP323.5″ Parallel TFT Display with ESP32-S3
€72.95excl. VAT€89.00incl. VAT3.5-inch TFT display with a capacitive touch screen, ILI9488 graphics controller, ESP32-S3 module and SD card slot.
-
Displays64×64 RGB LED Panel, 3 mm Pitch
€36.89excl. VAT€45.00incl. VAT4,096 individually addressable LEDs for text and animations: it measures 192 x 192 mm and daisy-chains to further identical panels.
-
Displays1.3” I2C OLED Display – GND/VCC/SCL/SDA
€13.03excl. VAT€15.90incl. VATModule with a 128×64 pixel blue OLED (Organic Light Emitting Diode) display, I²C interface, SH1106 graphic controller, viewing angle approx. 160°
-
DisplaysNEXTION NX4832T035 3.5 inch Display
€59.84excl. VAT€73.00incl. VATThe NX4832T035 is a NEXTION family display that differs from conventional displays thanks to an on-board microcontroller, flash memory, a card slot for the SD card holding your project firmware, a 4-pin TTL serial interface and free software (Nextion Editor) written specifically to design the graphics (buttons, progress bars, images, text, etc.). It offers 16 MB of flash memory, a 3.5″ resistive touch screen, 480×320 pixel resolution and 65,536 colours.
-
Displays4” 7-Segment LED Display Control Board with I²C Interface and Arduino Nano Support
€19.67excl. VAT€24.00incl. VATIt is modular up to 8 digits and mounts on the back of 4-inch (about 10 cm) common-anode 7-segment LED displays.
-
Mood lighting & gadgetsController board for LED matrix panels
€11.48excl. VAT€14.00incl. VATDrives a standard RGB LED matrix over a serial bus using an ESP32 board, with a choice of several versions.
-
DisplaysPROGRAMMABLE MESSAGE DISPLAY
€40.57excl. VAT€49.50incl. VATAdd an LCD display to your application to give it a high-tech look! Replace up to 9 indicators or lamps with a single backlit LCD display.
-
DisplaysMiniature Scrolling Message Display, 16 Characters
€21.31excl. VAT€26.00incl. VATMiniature board that shows messages of 16 characters on a single line of an LCD display
-
DisplaysTouch Screen Display 7″ – 800×480 pixels
€40.16excl. VAT€49.00incl. VAT7″ colour display with capacitive touch screen, HDMI video input and 800×480 pixel resolution
-
Displays4 x 8×8 LED Matrix Display with MAX7219 – Red LEDs
€7.38excl. VAT€9.00incl. VATModule made up of 4 matrix displays of 64 red 3 mm common-cathode LEDs (8×8), driven by the MAX7219 chip
-
Displays4 x 8×8 LED Matrix Display Module with MAX7219 – Green LEDs
€7.38excl. VAT€9.00incl. VATModule made up of 4 matrix displays of 64 green 3 mm common-cathode LEDs (8×8), driven by the MAX7219 chip
-
Displays0.95-inch Color OLED Display
€12.70excl. VAT€15.50incl. VATRGB OLED (Organic Light Emitting Diode) display, 0.95″
-
Displays1.3-inch OLED Display
€9.02excl. VAT€11.00incl. VATBlue OLED (Organic Light Emitting Diode) display, 1.3″
-
Displays128×64 OLED Display – White Characters
€22.95excl. VAT€28.00incl. VATModule with a 2.42” OLED (Organic Light Emitting Diode) display, 128×64 pixels, white characters, SPI / I²C interface (SPI by default, for I²C see the table), SSD1309 graphic controller, viewing angle approximately 80°
-
DisplaysNEXTION NX3224T028 2.8-inch Display
€45.08excl. VAT€55.00incl. VATThe NX3224T028 is a display from the NEXTION family that stands apart from conventional displays thanks to its on-board microcontroller, flash memory, SD card slot for loading your project’s firmware, 4-pin TTL serial interface and free software (Nextion Editor) written specifically for laying out the graphics (buttons, progress bars, images, text, etc.). It has 4 MB of flash memory, a 2.8″ resistive touch screen, 320×240 pixel resolution and 65,536 colours.
-
DisplaysNEXTION NX3224T024 2.4-inch display
€40.16excl. VAT€49.00incl. VATThe NX3224T024 is a display from the NEXTION family that differs from conventional displays thanks to a built-in microcontroller, flash memory, a slot for an SD card holding your project’s firmware, a 4-pin TTL serial interface and free software (Nextion Editor) designed specifically for laying out the graphics (buttons, progress bars, images, text, etc.). It offers 4 MB of flash memory, a 2.4″ resistive touch screen, 320×240 pixel resolution and 65,536 colours.
-
Displays0.91” I2C OLED Display, 128×32 pixel
€4.84excl. VAT€5.90incl. VATModule with a 0.91” OLED (Organic Light Emitting Diode) display, 128×32 pixel, blue, I²C interface, SSD1306 graphics controller, viewing angle about >160°, ready to connect to Arduino
-
Displays16×16 WS2812B Neopixel LED Panel – Flexible
€40.16excl. VAT€49.00incl. VATCombined with Arduino, Fishino, Raspberry or any other microcontroller, this flexible panel with 256 Neopixel LEDs (16×16) and WS2812B chips lets you create animations, text, drawings and more
-
Displays1.44 inch TFT Display with ST7735 Driver
€9.43excl. VAT€11.50incl. VAT1.44″ IPS colour LCD display module with a high 128 x 128 pixel resolution and a wide ± 80 degree viewing angle, driven by the ST7735 controller, with SPI interface.